Jet BMX Freestyle Street Tyre - 20" x 2.2", 2.35" - Camo, Black

Amazing product for a little project I was working on for my son they look amazing on his BMX and fit a treat but they are cheaper to get them direct from source bmx.

It was a good price. I did not know it was going to be a little less wide than my existing bmx tires, but they had to be replaced. Maybe I can go faster with these tires being that they are just a little more skinny. Racing bikes have really skinny tires. Whatever this tire is, it is probably a little more wide than a racing bike. I fit it on my bike and used my old existing tubes without issue. I used a tire remover tool. I keep letting out as much air as I can to get it all off and then fill up the tube a little and stuff it in the new tire so that it can easily fit properly. I do not know why I thought my tires was 65PSI. I have multiple bikes and it could be confusing. The tires I removed were over 100PSI, but I could not allow myself to believe that what I bought can't be used. One of the bikes in my garage might be 65PSI but it is not the one that needed new tires. I am not going to be fussy about it. I will try to enjoy these new tires. I have tested out this pair of Jet Freestyle Tyres with a few rides since installation. I have had no blow outs but I did not have any accidents. And it is not like I would actually try to blow out my new tires right off the bat. I am an experienced rider. I know a really good tire will not easily blow out when I accidentally may land a bit on a sharp curb with it, but that would be my mistake and I can't think there is some miracle tire that would never blow out with my accidents. Cornering is a little more difficult than the previous tires I had, but I will use the Jet pair now until I wear out the tire. I do not use a pressure reader. I am not that heavy and I use use my hands to feel the tire and I get on the bike and look at the tire while I pump it, and do that until it is where I want. I fill the tubes up good but not to the point that would result in a harder ride and a loss of flexibility, and not too low that it could easily blow out. I may tend to put very slightly less air in the front wheel tube and that way my hands don't have to feel the bumps in the side walk too stiffly. I also have fit 2 different kinds of fingerless gloves on my left hand and the right hand; that is a total of wearing 4 gloves at the same time. This idea is to make more of a cushion. I put an extra soft insert over the existing internal soft pad, into my choice of riding shoe. But if anyone else tries multi-inserts be careful not to turn your ankle; it could happen once you have 3 or more inserts in a shoe. Jet BMX Tyre is an inexpensive tire and I think it is worth the price they ask for it. It's not too weak for me. I do not know how long it will last but I couldn't say I did not get my money's worth out of this tire. Honestly, with any tire, it is so dangerous to try to do a fast wheelie, especially with no protective gear. The easiest wheelie is a slow kind, so slow that a rider can pedal at the same time. I'm not talking about motorcycles. A motor would also make it more like effortless to do. Theoretically people are more likely to die if they accidentally hit a brick wall at a high speed. Avoiding minor injury is also attractive to me. Smaller jumping allows me to still enjoy riding more than a plain old ride and not have to wear a bunch of pads and know that I am doing something with a much lower risk of injury. I thought I might get through the whole summer without a bad injury but I tore my knee open by accident and it is healing now. That happened before I installed the new Jet Tyre tire brand. It happened when I switched to smooth grind pegs from grippy foot pegs and I did not realize I got floor cleaner oil stuck on my shoe in my kitchen. I'd love to write a story about it. Most people would have gone to a doctor maybe for stitches. I did not do that. I treated myself. Luckily the wound appears to be closing and it was a deep gash. But I am not that stupid. If it didn't get better I would go to a doctor. I have not had 1 accident since installing the Jet Camo Black Street Tyre. I am more likely to ride on the street because the only skate park near my house is a tiny park for kiddy skateboards but could be used in smaller ways. In fact, there is a sign at my local skate park that says no bicycles, but they will not kick you out if you dare to use the small boxes. The next town over has a little more of a skatepark, but still is not made for bmx bikes. I don't think anyone makes big air parks and gives free access to the public near me. I like free parks. I also installed new pedals again and a new seat post. It is a restoration. I have 48 spoke rims so that it can be matching numbers. I liked those bikes they made in the 1990s. One guy was going to throw this out and asked me if I wanted it. I have spent considerable time and money rebuilding this and rode it for a number of years now. I also took days to getting rust off of it as much as possible when I first got it. It was just sitting in this guy's back yard and he reached out to me and asked if I wanted it. I said I would take it. I have replaced everything except for the brakes and the fork and the core frame. 1 time the original handle bars snapped and I had to try to muscle the bike to stay upright and I did not fall off. The pegs are new again too and they sent me screw on pegs. I still use bolts on the inside and I would have returned them if there was no room for an enforcement bolt inside. The screw on peg can help me align the wheel before I put the final bolt in there like I always do with pegs. I cleaned this bike again in the middle of installing the new Jet Street Tyre because I had the wheels off. These bikes are easier to work on. Here is a picture of my bicycle. I have other bikes too. I have to have a brake on both wheels because I ride this in traffic and I want to make sure I can stop without overusing my shoe to stop.

Buen producto,montado y funcionando

My grandson has been receiving a lot of compliments about the look of his personally hand painted bicycle since the new BMX tires were installed! The tires are both smooth riding and built strong!

Compré las cubiertas para la restauración de una BMX. Le quedaron perfectas. Aspecto negativo a destacar es que vinieron un poco deformadas, si ponías la cubierta en plano notabas una ligera curvatura, pero con dejarlas un rato en plano con algo de peso se arreglan.La calidad bastante decente para el precio que tienen.El producto viene con pegatinas, tienen buen diseño.

Self explanatoryIt's a tire, works like a tire, rolls