Thinvik 1-Pack/2-Pack Bike Frame Sweat Guard Sweat Absorbs Prevent Bicycle from Corrosion for Bicycle Trainer Indoor Cycling Training

This works fine and does a good job covering the areas on the bike that used to get all sweaty. I have an old cannondale on my CompuTrainer that had lots of corrosion on top tube and around cable bosses from sweat dripping over the years, due to not having one of these. I had it cleaned up and repainted, and this does a nice job protecting the bike. This covers well, fits well, easy to install, and it seems well made so it should last. I got a two-pack and even then it was not expensive. It installs on handlebars right at end of bar tape so doesn't get in the way. Overall a good product, well worth the small amount of money it cost.

I purchased the item as I was concerned about sweat causing corrosion damage to my bike while riding indoors on the trainer.I tend to sweat heavily during high intensity long rides.The sweat cover works great and the universal fit should fit most bikes.I tried it on 6 different bikes and it fit every time.I have washed the sweat guard in the washing machine and then air dried - with no issue.I highly recommend this product to anyone riding indoors on a trainer (especially during winter months when your heat is on)I give this product 5 stars and highly recommend

I got this set for my wife and my training bikes. The bikes stay inside for use on the trainer so sweat build-up and damage from it is a real concern - something I have had to address a few times so far.So anything to help absorb the sweat and protect the bike is good.These seem to be similar to others of the type and do their job pretty well. They are thick and stay in place while riding which is good. Moving the bikes can pop one side of the velcro off but it's easy to reset it as needed.They could use a little improvement in design but they look good and do their job well.

i've used these guards on my bike when stationary cycling Well done, work as advertised.

I have had other ¨trainer towels¨ in the past to drape over the top tube and handlebars. This has a bit more ¨custom fit¨than what I have used in the past and will serve well to protect the frame as Sweat away in the winter. This was a good buy. Don't buy one though, but two so you have a reserve to use!!!

Great product, thank you

UPDATE: Well... I finally tossed one of these because it just got too stinky (no fault of the product). I hand washed it, but to no avail - it found its way to the trash bin. Using my last one, I felt exposed - so have ordered another 2 pack. These things are great! Still holding at 5 stars. I'd give 6 if I could._________________________________________________________I've been riding my old rollers for winter training. These are life changing. I did a 55 minute roller ride today, dripping sweat and not worried one bit about my old steel framed bike. A god-send. As per the title of this review, too bad 5 stars is the limit. These are priceless! GET TWO!

Straight forward product. One end fits around the stem of the seat, the other velcros around the handlebars–the fabric in between captures the sweat and protects the bike. Probably works fine on normal road and mountain bikes, however not the best fit with TT bikes.Everyone's setup is a little different, but for me this products falls short around the handlebars. The material doesn't cover the cockpit and the straps aren't long enough to weave through the aerobars and reach back to its velcro connections. The best I can do is secure it around the elbow pads, leaving the handlebars and aerobars exposed. I'm still using a towel to capture most of the sweat that falls from head / face.Also, this product is not machine washable. As you can imagine, it can get pretty gross.In short, for me, the product protects the frame of the bike but offers nothing up around the handlebars.