FoxAlien Masuter Pro

おおむね満足。 コストがそれほど高くないので、モーターのパワーが若干不足気味。 したがい、深彫りする時の刻み深さはあまり大きくしないような注意が必要。

What are fabulous piece of kit, arrived on time and in the most fabulously packed boy in layer and layer of foam. Has kept me amused for hours. Had a small issue with a limit switch and contacted fox alien customer services who where so helpful, they diagnosed the problem which I replaced the switch from the spare from my delivery, they then sent me a replacement which arrived in a couple of days. Now works perfectly real customer service.

I'm very happy with my purchase. The packaging is perfect keeping the machine parts protected and in order. You can tell its a quality product just from the packaging. Easy to assembly with very simplified posture manual. If you have assembled an IKEA product before this is alot easier and simpler. The machine itself feels high quality and very sturdy. Trye out and works perfectly, i love that it is upgradable and gives the feeling of a professional mashine. I was happily surprised to see that the packa included some spare parts as well. Highly recommended 👌

Una maravilla, funciona perfectamente y es muy fácil de usar

Purchased the MasuterPro 4040 with router. Set up and assembly took no time at all. Literally less than 30 minutes. Ran accurate cuts right off the bat, no headache trying to dial it in. Is it a machine that’s gonna allow me to make parts for the next SpaceX launch? No. But for as inexpensive as it is, it’s pretty amazing what it can do and the quality. It’s fairly quiet, the sound of the material being cut by a bit is louder than any of the motors. A week later I purchased the 40W laser and 4080 extension. I’m planning on using it for guitar making. Haven’t run any on it yet, but tested some smaller patterns on hard maple, ebony, and mahogany and it seemed sturdy and strong enough. Bit quality matters, rpm and feed rate as well. Don’t expect this thing to cut a guitar body in 10 minutes, cleanly. It’s not a $100k rig. Software (not FoxAlien- just the process and technology as a whole) is a bit of a learning curve for doing advanced design and making but if you are looking into CNC, I’m sure you are sharp enough to get over that hump.

Ist schon ein tolles Spielzeug. Kann eine Menge schöner Sachen mit herstellen