Panari 753-1225 Carburetor for Ryobi 650r 825r 825RA 875r 890 890r Yard Man YM21SS YM26SS YM26BC BrushCutter MTD Troy Bilt TB415CS TB425CS TB465SS TB475SS TB490BC Trimmer

Panari 753-1225 carburetor, installed onto Troy-built TB490BC (4-cycle power head for trimmer - brush cutter, blower, etc.) Fit correctly and the engine fired up fine. Only noted difference form OEM engin is fuel in / out ports face rear (towards bulb) instead of straight up (but no fit issue, in fact it is better), and the hole in the throttle plate was small. Drilled out to fit my throttle cable holder. Plate is same thickness, so the washer and snap-ring fit on just right after installing. Initial idle was OK with no adjustment. After about an hour use, had to adjust idle screw to keep throttle open a bit more for correct idle. No change after second hour of use. The small hose clamps are actually slightly large, so not of any apparent need. fuel filters appear to be good quality. All in all, very good for the price. (my existing gasket was fine, so I did not use the included gasket.)Edit: June 2019. This now has about 25+ hours of run time. It holds idle well, starts right up, and runs fine. No issues with it.

This one was easy. It was an exact replacement for my original carb. Only needed a slight adjustment once warmed up. The response was instantaneous and the tiller never stalled once the new carb was installed. Being a retired auto mechanic rebuilding a carb would be easy for me but in the end, this is much better as the cost was almost as much as the rebuild kit, new hoses and carb cleaner would have been. So, a much more productive choice in my book. And best of all... less work.

Replaced a clogged carb on a four stroke weed wacker. It was not too hard. Four screws and hooked up some fuel lines, and my wacker was up and running again. Think it took me about 30-45 minutes to remove the bad one and put the new on on.

Bought this to replace the carb on my Ryobi 825R 4-cycle trimmer. This carb does not not include the throttle pin that the throttle cable hooks into and the hole is too small to transfer the old pin directly. Once drilled out though, the pin can be fitted and everything works fine. Also, I tried to reuse the original gasket since it was still in decent shape but found it interfered with the throttle on this carb. The included replacement gasket looks a little different but works fine.

This was a great carb at a great price. Easy to install on my Troybilt cultivator tiller. After installing primed the carb and started right up. Been running great! Will buy another for a backup at this price! Great carb at a great price!

The only problem I see is that the fuel lines should be different colors, and a new gasket would be nice. It’s easy to install and a very good value for the cost!!

The carb kit was easy to install and had extra part. The best thing is that is works great and was well worth the money. Followed the start up direction on the trimmer and it started right up with no adjustment.

I bought this to replace the carburetor on our Troy-bilt Superbronco TB415CS weed-eater. I wish I had found this pack first - we had already bought and replaced the fuel filter and fuel lines!Everything fit perfectly and the trimmer runs like brand new. Great price for everything you get. We've now got a small bag of spares for future seasons.